Hey guys im new to RC. Ive got a Losi Micro 1/24 Rally Brushless.

Sadly the servo have stopped working randomly. Doing some reading on the forums... the servo may have burnt out because i had the dual rate steering on max... and the steering trim was set to very "one side" to straighten the car. Before the servo broke i noticed the steering was very jittery when the car was still.

Losi no longer makes the servo... its the brushless car with 5 wire servo. Ive found lots of 3 wire servos online but the 5 wires i cant seem to find the correct size.

Ive found this online (im in UK): AZDelivery SG90 Micro Servo 9g


I assume i can buy this and simply remove the motor and re-wire it into the original losi servo case? I assume its the motor the burns out and not the controller inside the servo?

In anyone knows of a easier direct fit or easier way of doing this please advise.

Thank you
Pingster