Still Waiting on the mail to bring the RX4/2300kv HD. For some damn reason, they sent it from Georgia, to Texas. I'm in Michigan.. SMDH.
Anyways, I want to Ace Is the Place Hardware to get some spring steel. They used to carry it. Well lets just say Ace Isn't much different than any other box store today. No rod style spring steel though thy used to carry it here locally.
But they did have some Nice T handle allen wrenches and one was 2.5mm and 10ish inches long. And its US made and made out of quality spring steel. So 150mm whacked off and I had a good cross bar to moun the Vanquish V2 Yeti Sway Bar. Added a piece of fuel tube as bushing holds to hold the brass guide bushings for the crossbar. So Mounting the Sway bar as designed by Vanquish is doabl with about 150-153mm of 2.5mm Spring Steel rod.


Now for the bad. The bars are overall, very nice, Just a bit too short. I had to mount in the rear most mount on the sway bar, and the down links are at a decent angle in relation to the front axle. cant move it forward any or the sway bar will be uselss.

So if you're looking for a sway bar atm, I would suggest the stocker, the Treal, or the Vitavon as they are the only options atm.
Thinking I will order the Treal unit. Might need to get a better piece of spring steel (another 5.00 Long T handle Allen Wrench from Ace) that is 3 or 3.5mm for a better quality crossbar, but so far, most are not having any issue with it.

I have a vid on my youboob channel (live) on its install and I end the vid with a few minutes on my thoughts over the diff issue, and the probably solution or fix for them.

I'll get a few pics and make some runs in the next few days with the current sway bar, and get the Treal ordered and on the way.