Brief read over and just wanted to double check a few points on the RX8 Gen3

1) 12 awg is perfectly suitable for power and motor wires? I normally default to 10 awg on my 4S bashers but the solder post would be a little cluttered trying to wire up 10 awg

2) as it doesn’t run ‘Lipo auto-detect’ I can just wire up an LiHV with no need to change settings

3) I’ve seen a few comments about leaving the HW3 connected but as it uses the fan port wouldn’t that meant they have removed the fan or powered it separately? Assuming you can’t run a splitter?

4) I’ve been able to set the RX8 via my iPhone and HW3 but can never get a connection when using my PC, I just keep getting a ‘check connection’ error given the HW3 works via BT I’m I right in assuming the error is most likely related to my PC setting up?

Thanks