Originally Posted by
choisan
can someone suggest how to install roll center spacer when the Pro-Strut Graphite Brace was already installed with Long Dual Upper Mount.
i shall
- insert it under the Pro-Strut Graphite Brace with longer 4-40 & 8-32 screws with nuts?
- use only short upper arm and roll center spacer?
below is what i ended up, don't install the roll center spacer, just changed to ry the 10 degree caster block
should i stack it up with longer screws and nut?
Your long arm dual mount Pro strut brace is already a roll center spacer. I run the long arm Pro brace on a 10th scale car and I just use longer 4/40s to hold the brace down. Warning, I never could get the probrace/ roll center spacer to work right on black carpet on a 12th scale, it was a little to aggressive, I could turn in a good lap or two at a time but that was about it, but if your car needs some aggressiveness in the steering it might be the ticket..