Originally Posted by
the rc guy
Good luck you have a big task ahead of you.. I think the batteries are your limiting point . you can use batteries in series or parallel.depends on voltage and amp needs..in order to do dual motor than can turn boat you will want to use 2 esc with radio mixing. best of luck. the rx gets voltage from esc bec. if you run 2 you will want to disconnect center wire on 2nd esc(+ wire) . cant run 2 becs into rx
I.knew about the 2 escs for dual motor but didnt knew about the + wire.
The receiver says 4.5v to 6v. So I need at least two 18650 in serie correct?
Noticed the ESCs have a bec voltage value, só that value must be anything between 4.5 and 6v correct?
The ESCs also have a bec Amps, i dont see any amps requirement on the receiver. How do i know how many amps do i need in the receiver? Or the amps on the receiver are only for servos?