Starting voltage can be anywhere from 3.56 to 3.60. I am putting the charger into Lipo Charge mode. When I start charging the pack it might charge for 30 seconds at the most then give an error code showing Balance Process Error, this is after the charger goes through the battery check process after hitting the start button.
There is a rare occasion the charger will continue to charge the battery however it will only charge to 3.89 to 4.00 volts and never reaches 4.19 - 4.20 volts. According to a chart that I found this is basically on the lower side of 80%.
Thank you for the replies and helping me try to resolve this issue.