Hello. I'm setting up a 1/10 drift car and I wanted to try Sanwa for every electronics part.
I have:

Tx: MT-44
Rx: RX-482
ESC: SV-D2
Servo: PGS-LH II
Gyro: SGS-02

I wanted to get the best response modes possible for servo & esc and the possibility of programming ESC, gyro and / or servo with the Rx (I don't even know if it's possible to do it with all 3 elements). I'm trying to follow all the documentation I have but still not sure which one is the right way... docs are sometimes hard to follow and not very complete explaining what is SSL, CODE AUX, CODE10... I'm getting and approximate idea but still I'd like to check with you. Right now I have my setup like this:

Servo (out) -> (servo in) Gyro (servo out) -> (channel 1) Rx (SSL input) <- (throttle) Esc

Gyro (SSL out) -> this cable is not connected to anything, if connected gyro stops working at all... no idea. I though I had to use a Y harness cable to connect both servo & esc to SSL input, but if I do this, gyro doesn't recognize my steering input and wheels don't even move.

Any help? thank you.