Received my rear axle housing week before last. Started to replace it and the the set screw in the universal stripped. Had to drill it out and ruined the universal. Also found out the slider for the rear drive shaft had fell out when the axle housing broke. Put new axle housing together and it had a real tight spot, pulled it back apart and found short side axle bent slightly. Had to order axle set, drive shaft set, and universal set. Got those this past week. Took Ryft out for a little run on a dirt pile and about 5min in the left side lower control rod end broke at the chassis. The one with the angle. Had a straight rod end from a sway bar kit and switched to those. So Ryft back together. Looking at the rod ends, AE's 1/8 scale rod ends will fit I believe. Going to order some and see. From racing ebuggy and truggy I know they are tough. Got the bug so I built a DB48 also. Playing on the dirt pile it work good, can't wait to get out to some hills again. I have the Tenacity DB Pro cage mounted, waiting on body panels for the cage for it. Hoping to go out this weekend and hit some hills.