I was wondering if there was any information anyone could provide me with regarding the swap on the ch3 button to a potentiometer on the GT3C. I just can't figure it out, and I can't find any information online about it, unless I have missed it sifting through 4 or 5 hundred pages on forums in the last couple hours.

I have the radio updated to 0.6.1 firmware, I have it set to use ch3 as pot in the global config, and I have ch3 set as ch3 on the radio to the receiver. Now, I just can't figure out the wiring. Nothing I do gets the pot working on channel 3,im checking through the calibration and using smartproproplus on the pc directly to the controller, and to the Arduino based receiver adapter I made.

Where do i hook up the wires of the pot on the controllers board? Which resistor do I eliminate? I'm assuming the resistor is labelled r18, as its the one that is inline with the ch3 button, according to my multimeter. Some help would be greatly appreciated. I need another real axis added to this controller for one of my rc projects. Thanks a bunch in advance.