I would like to know if anyone here has used a high voltage BEC setting (8.0V to 8.4V) with high voltage servos and a Traxxas TSM receiver.

I don't want to burn out a receiver if this doesn't work.

I already know that the instructions say it should be connected to 4.8-6.0V "to bind."

I called Traxxas before posting here and to ask if the TSM receiver was compatible with 8.4V BEC and all they said was it "should" work.

To me, "should" is not the same as "does". It indicates conjecture rather than knowledge.

I would like to know if it "does" work (from someone who has done it) or if it "doesn't" work (from someone who tried it and burnt out the receiver).

Is there such a peron (or persons)?