R/C Tech Forums - View Single Post - SC10 Thread Part 2
Thread: SC10 Thread Part 2
View Single Post
Old 03-02-2021 | 10:49 PM
  #4386  
rustyus's Avatar
rustyus
Tech Master
iTrader: (1)
 
Joined: Apr 2014
Posts: 1,296
From: PA
Default
Originally Posted by RCDOOD88
The servo arm wont make a difference. And it is all original anyways. The linkage that runs from front to back is what hits the top of the servo. The stock servo "top" is angled slightly. The aftermarket ones are squared off. If i could post pictures or even links to pictures it would make more sense.
Gott Cha. Sounds like a standard servo with no wiggle room when mounting it. Reminds me of one of my JX servos that had a lot of material on the top of the case. Little bit of Dremel grinding and it turned out really well. There was a moment I thought this was a bad idea.




rustyus is offline  
Reply