Originally posted by TAW
Well, after tearing down the car it looks like my 4mm chassis it slightly bent in the front. On a flat surface the front area where the bumber mounts is about 1~2mm off the surface. Weird part is it almost looks exactly even side to side so its odd that it only affected right hand turns. I guess a tweaked car will do wierd stuff?
I noticed this with my R40 this afternoon while taking my car apart, perfectly even, but the front was a tad higher.
I think that there is a lot of twist going on from the belts and pulleys, add a 1.4-1.7HP motor to the equation and it might make since. That could have caused the problem.