R/C Tech Forums - View Single Post - LC Racing EMB-1H Official Thread
Thread: LC Racing EMB-1H Official Thread
View Single Post
Old 02-18-2021, 07:12 AM
  #2725  
smirkracing
Tech Addict
iTrader: (19)
 
Join Date: Feb 2017
Location: SF Bay Area (south bay)
Posts: 646
Trader Rating: 19 (100%+)
Default
Originally Posted by liquoredonlife
I built my EMB-T with the aluminum bell crank, knuckles and hub carriers. Also got the bearing pressed steering linkage from EAC Engineering on Etsy. Shimmed with .3mm thick shims behind the stub axle pins to minimize CVD slop. I have virtually no slop.
Thank you!!

I have the linkage from EAC (not yet installed) but i have been staying away from the aluminum knuckles and hub carriers because I was concerned about weight. Sounds like that has not been an issue for you?
smirkracing is offline  
Reply