R/C Tech Forums - View Single Post - Digital Servos from China
Thread: Digital Servos from China
View Single Post
Old 02-02-2021 | 08:30 AM
  #230  
billdelong
Tech Champion
iTrader: (33)
 
Joined: Mar 2011
Posts: 6,410
From: Austin,TX
Default
Originally Posted by RC*PHREAK
well...not off to a good start with the MKS servo. i can't get the screw into the center of the spline to hold the horn on. it just won't start to thread on. like the top isn't machined out or something. i can see there are threads inside, i just can't get the screw started. tried several M3 screws. sigh....
do you have a M3 tap?
billdelong is offline  
Reply