Originally Posted by
stephen_bess
Nice review. I built mine and I noticed you didn’t mention grinding the right rear suspension arm for spur gear clearance. I had to remove quite a lot of arm material for clearance at full up travel. Also, the receiver box is sized fine for Sanwa/Airtronics receivers. This is designed as a racer’s kit IMO.
On the arm grinding, you're right. Should be visible in my photos but I will add to the itemized list. And as far as racer vs. basher etc, plenty of racers use Futaba (7px). There will barely be enough room for a small receiver and the additional wiring in the box.