RCTecher1337

I am running on carpet inside my Apartment (I would consider it comparable to RCP traction wise) and using the stock brushed motor. This is how I have my B setup.

3x6x2.5 bearings in bellcranks
x1 .13mm spacer on each side of bellcrank arm
Zip tie on servo saver

Front Suspension

0 Toe
-1.5 Camber
Ride Height slightly raked

Shocks
27.5 AE Shock Oil
2 Hole Piston
x2 2x2mm o-rings
Gold Spring
Inside hole on tower/Outside hole on arm

Camber link ball inside hole

Spacer Locations
x1 .13mm spacer inner front a-arm
x1 .25mm spacer inner rear a-arm
x1 .13mm spacer outer rear a-arm
x1 .25mm spacer bottom of spindle
x1 .13mm spacer top of spindle
x1 .50mm spacer between shock and nut

Rear Suspension

-1.5 Camber
Reversed A-arms (adds 1/8" to wheelbase)
A-arms slightly below level

Shocks
27.5 AE Shock Oil
2 Hole Piston
x3 2x2 mm o-rings
Black Spring
Inside hole on tower/Outside hole on arm
Shocks mounted on inside of tower/a-arm

Camber link ball outside hole

Spacer Locations
x1 .13mm spacer inner rear a-arm
x1 .50mm spacer between shock and nut
x1 .50mm spacer between shock and a-arm