View Single Post
Old 08-14-2002, 04:56 AM   #3398
rjl
Tech Fanatic
 
rjl's Avatar
 
Join Date: Jun 2002
Location: OZ
Posts: 848
Default

Use the Kyosho collet. Use the 5x7 shims to space the bell so it will not rub on the flywheel.
I did this same installation on my first voner and things work as they should. The 7x11 washer may be needed if you have too much end float, unfortunately you may need to trial fit the whole assembly a few times, do not take short cuts here. I have seen crankshafts ruined by poor assembly of the clutch.
rjl is offline   Reply With Quote