Originally Posted by
RedDevil13
Another comment. I ordered these arms and built the kit with them. WARNING!!!! the arms are about 1mm wider at the inner hinge pin than the stock harder arms. I assume you could re-shim it with smaller shims, I just sanded the arms down a bit to get the width correctly.
Also, I had a dragging sound when I would rotate the drivetrain. I found it was the 2 metal shims they have you install between the center spur gear and the uprights. I removed both and there was no longer a drag. I may need to reinstall 1 of them after I run it, but so far it doesnt seem to be sloppy without the shims.
I have ran my M20 in 8 race days and as many practices with all original parts and have broken nothing, and I am not an A main driver.
Run an Axon DTS spur gear they do not need to be shimmed.