I have officially put the following servo to the test tonight:

• AGF - A80BHMW 31kg.cm(430oz-in) @6.0V - 0.120sec/60°@6.0V

I have been running the optional locked servo saver with this servo and I botched a landing with my nose into the face of the jump and I originally thought I stripped the servo gears, but turned out that I stripped the teeth inside the TEKNO Aluminum servo arm instead, wow! And yes, I had it fully clamped down with thread lock... if I keep stripping these aluminum servo arms, then I might have to go back and install the spring style servo saver, doh!



Surprisingly, the teeth on the servo spline didn't strip, I bought a replacement servo arm and it ran flawlessly the rest of the night of racing without issue, though I drove a lot more clean