EB48 2.0 issues
Can’t really say if it’s an issue with the buggy or not. I’ve had 5 ESCs burn up. They will just stop putting power to motor. I’ve burnt up one Tekin rx8 - 3 hobbywing Xr8 plus. And a hobbywing SCT. I’ve also tried 3 different motors. It very random when it happens. The last one I put in about 20 laps everything was fine. Let cool down and ran two laps then it quit. I’m leaving all esc settings factory. I’ve also swapped the receiver. I had multiple people look at my solder joints with no issues. I follow programming per instructions. I’ve also tried two different sensor wires. All ESCs and motors have been new. I’ve tried two Tekin G3’s and a hobbywing 1900kv. The esc and motor never get about 150. I’m lost. Any ideas?