Originally Posted by
30Tooth
Yep no luck finding it... So here goes the changes, rear camber link using the inside hole on the upright, -1 camber and top hole on the bottom of the upright. Front 2.1mm roll bar, B kick up parts (think it's stock...) and front holes on the steering rack.
If not mistaken the hyper 7 spur is compatible.
Thanks for the info, I shall investigate changing setup. Too hard to find parts for the 7.5, now I'm stuck (I've checked the Hyper7, different case hole locations) and a buggy is sidelined. There are other brands like redcat/hsp that are very compatible but like anything here in Canada there is nothing around - have to do expensive shipping from the states. There is a roller TKI4 kit that I can buy not too far from me for $250, I think I am going to go for it - giving up on the 7.5's I think. Too bad, recently bought $250 spares but I only bought collision concern ones rather than wear concern ones.