R/C Tech Forums - View Single Post - Stripped screw with locktite
Thread: Stripped screw with locktite
View Single Post
Old 08-20-2020, 04:07 PM
  #10  
Zerodefect
Tech Champion
 
Zerodefect's Avatar
 
Join Date: Apr 2008
Location: Columbus, OH
Posts: 5,620
Default
Once the aluminum piece and carbon plate are apart, you'll be able to grab what's left of the bolt with vice grips. 3mm might be plenty to grab. Heat the threadlock with a torch. It'll melt at high Temps into a nice lube sometimes.
Zerodefect is offline  
Reply