Originally Posted by
ShootHere_
Brains trust, question regarding basic build/setup problem I'm having.
Trying to get the front setup but somethings off and for the life of me i can't work it out.
Using the kit measurements for the links (all spot on) then trimming to get the toe equal (which says to me the wheels are straight), the camber is way off on one side, ie left is correct (or very close) but the right is over -3
clearly something's not right, but i have no idea where to look and hoping someone might have a clue about where this might be going wrong
I'm not an expert here, but I'd check the ball studs. Are they in the same locations, and do they have the same number and thickness of spacers? Yes those tiny .5mm washers change the camber more than you would expect.