R/C Tech Forums - View Single Post - Team Associated Rival MT10 thread
Thread: Team Associated Rival MT10 thread
View Single Post
Old 04-13-2020 | 11:09 PM
  #9  
RazorRC's Avatar
RazorRC
Tech Elite
iTrader: (5)
 
Joined: Oct 2017
Posts: 2,002
Default
Originally Posted by RivalRunner
Hi all...new to the forum and to R/C as a whole...Just purchased a Rival MT10 today...just wondering if there is anything else I should purchase as far as spare parts, tools, etc...any insight for this newbie would be greatly appreciated. Thanks in advance.
A good hex driver set, I highly recommend spending the money on a 1.5/2.0/2.5mm driver set from MIP. 7.0mm for the wheel nuts too.
Replacement arm set from a Helion Avenge MT is a really good idea, for some reason the Associated arms are much weaker.
A temp gun to measure motor temps. I think that's about it, the truck is quite good.
RazorRC is offline  
Reply