R/C Tech Forums - View Single Post - Cyrul's Break in Procedures
Thread: Cyrul's Break in Procedures
View Single Post
Old 05-03-2005 | 12:16 PM
  #20  
cdelong's Avatar
cdelong
Tech Master
iTrader: (12)
 
Joined: Jul 2004
Posts: 1,805
From: The Sunshine State
Default
I take it down to bare bones- just leave the bearings in the block. I have a RB V12 arriving tomorrow and think I'll try this break-in method on it. I've never had a problem with "puttering" around the driveway around 200- 220F, but this sounds quicker.
cdelong is offline  
Reply