Originally Posted by
antlockyer
- 38.2mm front tyre diameter with superglue on the sidewall to prevent grip roll
- An alternative front end fitted that was made by Mr Cheng, steering throw is measured on a setup station and usually expressed as degrees of inside wheel at maximum steering travel
- Uses the Avid kingpin which is an alternative design that I think does away with the upper eyelet. Uses Green spooge grease as a damping agent (run damper tube oil on there to calm the car down)
- A 0.5mm shim is under the front side link ball stud, this is supposed to add some rear steer to the car and make it rotate harder
- The damper tubes have a 2mm shim under the outside, this makes them fractionally softer I believe, but happy to be corrected there.
Actually, front tire diamter is 39.2mm the 38.2mm is the glue on it.