Originally Posted by
thirtydaZe
Sorry, my plan really isn't to blow this thread up, but just getting into building, and was planning on using a ProTek 160SS servo i have on hand, but it's too tall. Looking around just a bit on Amain, most servos I'd like to use area ll about the same dimension.
What are you guys using that fits? The 160SS measures roughly 19mm from the bottom of the servo to the bottom of the mount. The manual calls for something 14-16.5mm..
you need a low profile servo. Futaba 9550 or 9551 works as well as any other low profile one.