Hi,

I am using ko propo RSx3-one10 Ver.D Lite as my steering servo, my car is Yokomo yd2s, radio is ko exrr

Everything are very new, the problem is when I turn left, then back to center, I need to manually turn right just a very very little bit in order to make it dead center.

The same problem happen no matter I am turning left or right in the first place, it just will not go center and is very very slighly off.

I check linkage and it has some play, and I think ot is normal, screw are not over tight.

Below are video showing the problem, any help would be appreciated