Originally Posted by
ryanster1999
Can anyone advise me on whats wrong here? When I attach the throttle arm to the horn in the correct position, it hits the servo casing. I have it on top, but its wrong, it should be on the bottom of the horn. However, my angle is perfectly straight when attached up top too. Is there any harm in running it like this? How can this be prevented? Thank you so much for any info that you guys can provide. Rctech has been a lifesaver throughout this build.
You could place a small washer/shim in between the horn and servo splined output shaft. Done it before. Just can be a pain to find that small of a spacer.