Originally Posted by
TurnNBurn
Did you find a setup to base yours against, or was that built according to measurements in the manual? Just asking, because that looks like a lot of toe-in at the rear. Then again, Based on the position of the links, it looks like it will open up a bit when it gets loaded up in the rear.
just i build with the standar set-up with some modifications, 2 degrees of camber all around and 1º toe-out at front and 2,5 toe-in at back, xray springs 2.5-2.8 front and 2.7 back, 37,5wt shock fluid.
serpent x20 default set up carbon