Originally Posted by
Speedychris22
Need some input, I’m installing a new servo in my car. I’m trying to get the servo horn as close to 90 deg as possible but it’s off. If I use subtrim I’m at 120 Right on my transmitter. Should I use trim instead? If I remove the horn and try to put at different angle I’m getting the same problem but now at 120 left give or take. Any input?
Hopefully you got this sorted by now, but just in case- make sure that you zero the subtrim before you reattach the servo horn. You may need to attach it rotated one or two splines over so that the wheels are pointing straight. If you're still having trouble check your front turnbuckles to make sure they are equal toe/camber or at least close to equal length.