Old 09-10-2019, 05:13 AM
  #13023  
Slotmachine
Tech Champion
iTrader: (4)
 
Slotmachine's Avatar
 
Join Date: May 2003
Location: Germantown Maryland
Posts: 5,784
Trader Rating: 4 (100%+)
Default

Originally Posted by Knockoffracer View Post
Need some advice, or tech help with the XR10 PRO 160a esc running a 10.5 G3 motor.

It will not work with the sensor cable installed. I need to push the car to get it to go, or yank the throttle back and forth until the car generates enough movement. I have replaced the sensor cable at least three times, replaced the Hall sensor, and replaced the capacitor pack after noticing damage to it. After all of this I still experience the same issue. Am I missing something?

Thanks in advance for any info. I've already been in contact with HW, they have been no help at all.
can you post your settings so we can see if there is anything wrong with your adjustments? You said you noticed damage to the capacitor, did it get plugged in backwards? Have you tried another motor?
paul R.
Slotmachine is offline