Thread: 3D Printing 101
View Single Post
Old 09-03-2019, 02:51 PM
  #7  
sacmiata
Tech Regular
iTrader: (25)
 
Join Date: Jan 2015
Posts: 448
Trader Rating: 25 (100%+)
Default

Originally Posted by Psychotikcow View Post
how have you like the ender pro so far? I'm looking to buy my first 3d printer.
I have liked it alot. I did some basic printed mod's like the filament guides. I probably have about 1.5 KG of material through it and its been solid. A few failed adhesion issues with PETG and the factory bed material. I purchased a glass bed and that has cured those issues.

I like the CR-20 pro that was mentioned especially at 315 bucks! When i bought my pro it was 209 shipped and i think the 20 pro was another 150 bucks. But for me i dont need a filament sensor and i personally like to level my bed by hand - its not difficult and i only do it maybe once every 5 prints just for good measure. Putting together the ender 3 was fun as well. If you like building model RC cars then I see it as a bonus to actually assemble the ender 3 (about 2 hours and watch the youtube video while you do it for all the tricks).
sacmiata is offline  
Reply With Quote