View Single Post
Old 08-23-2019, 07:39 AM
  #7  
johnnydmd
Tech Initiate
 
johnnydmd's Avatar
 
Join Date: Aug 2019
Location: Frederick, MD
Posts: 49
Default

I have an el-cheapo XYZ Davinci Jr 2.0, which doesn't do too bad for simple, small things. The only issue I have is the spools are often sent with the counter not being reset after winding. Aggravating as hell, because the only thing you can do is buy a new counter card, or you lose half of your spool.

I use Simplify3D for slicing, pretty good program.
johnnydmd is offline  
Reply With Quote