Originally posted by Merciless
I was also under the impression i had to use the BMI ali. pod plates as i have CRC ones but am sure they don't fit
I also use the 0.5mm increment adjusters and agree there very good
Thanks for trying
Rod
Will the CRC aluminum motor pod plates fit the BMI lower graphite motor pod plate? If so, then it's just a matter of the BMI top plate having four mounting holes and the CRC left side aluminum pod plate only having three holes. That's an easy fix. Just run a longer screw up through the CRC left side plate until enough of the screw sticks out of the top of the pod plate, cut a threaded aluminum stand off post to fit between the CRC pod plate and the underside of the BMI top plate. Problem fixed.
I ordered my BMI conversion about four weeks ago but I have not received it yet. (they had to cut out more parts) I can't imagine that they would total move away from the "standard" 1/12th layout for the motor pod.
Correct me if I am wrong?