Originally Posted by Kevin CBR

The older MRX6 used two 5x10 bearings in the clutch bell. The newer 6R clutch bell housing uses 4 bearings (i think 8x5x2.5). place three of the bearings on the motor shaft and the fourth up in the clutch housing then put the housing over the shaft. Your clutch issue may be you do not have all four bearings in the clutch bell housing. Steel City will be open for practice this weekend (Aug 17-18). Not sure if I will be there. After a week in China, an 11 hour delay on the flight back and three hourd sleep Friday morning before heading out to the Wallace Motorsports Showdown over the weekend, my body is in sleep deprivation mode right now. Good thing I went back to work today so I can rest. :-O

Panda