Josh is the KING....follow his instruction....dont add anything...

1. exactly what is is says several blips. Just get some good warmth into it...say a ~30 sec..just feel it make sure its good and warm.

2. not the whole tank....go directly to step 3.

3. again...keep opening slowly (while you are at WOT) until you engine shuts off (called a flame out)...yes imeediately start doing this when you reach this step..does it say to wait? (See what I mean....just follow the instructions!! easy) Just open slowly...like a 1/8 of a turn every 1~2 sec....

4. NO...does it say to go back to step 3??? LOL

5. Just enough time to add more fuel and go again...

6. Yes another 3 tanks

7. actually last time I checked 3+3 = 6. so it would be the 6th tank!!!

8. odd...you math looks correct there!!! LOL

9. no questions and self explanatory.


OK so I hope you sensed the sarcasm there in some responses!! Just do not add anything or do not change anything. Assume nothing and just follow the instructions.

I am sure you are confused in part because there are a million different methods out there. Thsi one is spot ON. A great method and no need to buy an expensive bench.

Just make sure you have an extra glow plug as you might kill one running so rich.

remember with tuning and break in rely on your senses. Sight, sound and touch...dont worry so much about the temp guns etc...

Also follow Josh's tuning method...hell all of his advice is awsome.

This break in method is like a recipe. You will have consitency with all your break in procedures from here on in. Just make a print out and have it with you when you do it. Follow it EXACTLY.

It isnt complicated if we just follow exactly as it says....

John