Originally Posted by
Sundling
I am experiencing something very annoying. After a runs down the straight, full throttle as I apply quick hard brake and then pushes throttle again the ESC brakes as I pull the throttle lever making it very difficult to take corners after a high speed straight. What setting am I missing out on? It almost locks up! Very heavy brake.
I am running tekin rx8 gen3 with tekin 2050 gen 3 motor. No sensor wiring. This stuff is the best I have tried out of any castle, Orion, or hobbywing combo have tried yet. Too bad I had to import this to Sweden. Or lucky me, cause this gives me a big advantage on my races. ��
I don't the understand the question fully. Are you saying that the car keeps brake when you're pulling the throttle?
And buy a sensor wire. This motor/esc is even better with the sensor wire installed. I have driven my combo 1 day without sensor cable because it broke and I didn't had a spare. While it worked, the throttle lagged a bit and it was hard to time jumps. With the sensor cable, this is much easier to time.