View Single Post
Old 07-23-2019, 02:45 PM
  #11  
andreas78
Tech Apprentice
 
Join Date: Jun 2010
Posts: 58
Default

Yes, as said before, if you want a perfect finish with Nylon, it needs to be as dry as it can be. But even PET-G and ABS should be dried again after a few weeks. I know that in many 3d printing forums people say, these don't need any drying. But have a look at the data sheets of manufacturers of these materials, that are also used for injection molding. They always recommend drying any plastics for a few hours.

Andreas
andreas78 is offline  
Reply With Quote