Sorry... I know its been a while. I just dont hv time to make a review.

Yes I did received the servo in a good condition.

The performance is great. The movement of the servo is super smooth. There is no slop at the gear at all.

The quality is really good. Even the grommet, eyelet and plastic servo horn is great.

If u like to use grommet and eyelet for the servo, theres a good news for u because the eyelet is for M3 screw.


Comes in a sealed plastic case


Specs for the servo. Rated for HV 8.4v


With form like that, should be no damage during shipping.


​​​​​It feels great to hold


Even the tidbits is good quality. The supplied screws are all hex screw


The 4 screw at the bottom have o ring install


Theres also o ring at the bottom plate


The yellow color is a plastic sheet. The board are covered with conformal coating. This servo is rated IP67 after all.


Sadly I cannot open the gear side because that 2 screws is H1.3 which I dont have any


I hv tried run it without the grommet. It can withstand the abuse. Set the servo saver a bit loose for longetivity.

Just another additional plus. The wires are all black except the sensor lead which in gray. I like the stealth look of the wires.