Originally Posted by
Garet Jax
Hello all,
How do I solder the ESC wires to the motor without touching the iron to the wire? There does not appear to be enough room under the 3 platforms to place the soldering iron.
Specifically I will be soldering to this motor.
Thanks.
To expand on what was said above, you just need to pre-tin the wire, and the terminal which looks to be done already. Then put a little tin on your iron, and touch the iron on top of the wire pressing down onto the terminal. The heat should flow with the solder on the iron, it'll heat the wire, then it'll heat the terminal.