Old 05-17-2019, 09:00 AM
  #12925  
Slotmachine
Tech Champion
iTrader: (4)
 
Slotmachine's Avatar
 
Join Date: May 2003
Location: Germantown Maryland
Posts: 5,772
Trader Rating: 4 (100%+)
Default

Originally Posted by refsiul22 View Post
Hi guys, I switched recently to HW in my SCT... was happy at the beginning, BUT..

XR8 SCT ESC / 3652SD G2 4300KV

I'm having the problem that after a regular jump (or hard landing), the car turns OFF. I turn it on again and it goes back to normal but the problem repeats again and again.

Sometimes, after a big jump (right after landing) I just lost TH for a few seconds (4-5 sec) while ST seems normal.

I'm kind of confused as where to start digging... I'm looking for possible answers (and similar experiences / solutions)

I don't think is a matter of temp, battery or bad soldering..... but honestly, I'm open to all suggestions.
First make sure the sensor wire is good and plugged in well, then go into settings and adjust the PVC to a lower setting maybe try a test and turn it off temporarily. I would also make sure the speedo and switch are mounted on a few layers of mounting tape to cushion the landings a bit.
Slotmachine is offline  
Reply With Quote