Hello I picked up a used T4 2018 and am trying match a set up from a sponsored driver but the eccentric bushings don’t make sense on the setup sheets. It seems to be the similar on several setup sheets. I’m coming from an older X-ray that didn’t use these bushings. Am I reading something wrong here? The roll centers should be in the same vertical plane to raise or lower and adjus dive squat but all these show differences in the horizontal plane which means it would affect toe or track width also. That’s fine but why adjust toe with bushings in the front? And even in the rear, some of the show pos toe instead on neg toe. One even shows 2.5 rear to which is not possible with the 0, 0.5 and 1.0 options. Does this make sense or are the setup sheets just not accurate?