Originally Posted by ROSCOE

Ok guys, I was waiting on a few parts to show up to finish my little brothers truck up and decided to mock up the jconcepts finnisher body. Overall it's a nice choice for those looking for something else. I would say it's as good of a fit as any. I cut just below the cut lines for the stock chassis and side guards (m2c chassis need to leave them longer) and followed the cut lines for the rest except the engine is shifted slightly left and back and the snipped the rear to fit around the tower/body mounts. The key with the body is to shift it back to get the engine closer to the cab and cutting around the tower rather than leaving it long in the back and having a bunch of the nose sticking over the bumper. Here are a few pics.





Hi, saw this thread, lucky to get a ST-RR Evo2. You mention JCONCEPTS Finnisher body, for which brand was it????, ie Mugen, TLR???
Regards