Originally Posted by
silden
this Layout isn’t really rear heavy.
I’m planning to cut a Servo plate to move the servo to the other side. The receiver would move forward right next to the servo and ESC right behind it. the Fan including the shroud could stay where it is right now.
A corner weight system sounds like a good idea until you realize what rabbit hole it is. replace the springs with something solid to remove the unknown factors like uneven springs. you can put the springs back inn to set the tweak.
You are right about the springs, it add some unknown factor. But it will be no problem, to replace it. I have 3d printer, so I can print some tubes exactly length and replace the spinrgs and have correct ride height. Balance car and then set tweak with springs. Thanks for advice. I will try it once i borrow the system.