Originally Posted by
RB_Racer
Out of interest i went looking for MSDS for Klotz Techniplate and Benol for the density information. All the ones i found Benol don't list density. If you are only making a quart/litre at a time to keep it as fresh as possible surely volume is easier option. If i was a fuel manufacturer and making huge volumes in vats etc then weight is probably an easier option especially if nitro/oil components are a little less in my favor being the most expensive part of the fuel.
Its just that smal volumes gets more critical to get right, so if a fuel mfg uses a barrel at the time it will deviate less if anything at all.
The information has been available for all Klotz products, and if nothing else the MSDS is in most (all?) countries mandatory to supply.