R/C Tech Forums - View Single Post - FK'05 failed thrust bearings only
View Single Post
Old 04-25-2005, 12:25 PM
  #18  
ChrisP
Tech Elite
iTrader: (11)
 
ChrisP's Avatar
 
Join Date: Sep 2003
Location: Shelby Twp, MI
Posts: 2,181
Trader Rating: 11 (100%+)
Default

If you are doing this to get the attention of Xray then youshould be talking about it on the Xray forum...

IF you have started this thread to let the Canadian distributor know what is going on then you should post on THEIR forum www.canadarc.net

The thrust bearings are a single cage. Apparently when they were ordered the diameter and material were spec'd, but not the cage type. Xray has talked to their supplier about this and is working on a solution. To say that "...they did not deliver on what was promised and they try and conceal it with offering a pre-built dif"...is a bit harsh....if they said carbide thrust balla nd the thrust balls aren't carbide you MIGHT have something to complain about..but to make a statement like that based on a difference of cage material is ridiculous.

I encourage you to contact your distributor if you have a problem with the car. RCAmerica and CanadaRC have both putsystems in place and listen to their customers.

This is a third party forum that DOES have some activity by Xray, CanadaRC and RC America, but I'm sureit is not watched as closely as the direct communication.
ChrisP is offline