View Single Post
Old 03-14-2019, 11:09 AM
  #1  
WhiteLX
Tech Adept
iTrader: (6)
 
WhiteLX's Avatar
 
Join Date: Oct 2003
Location: Riverside, CA
Posts: 141
Trader Rating: 6 (100%+)
Default SkyRC TS50 ESC calibration

I am having trouble getting my new SkyRC TS50 ESC to enter the calibration mode. It states in the manual to hold the power switch until it beeps once then 3 more beeps and a red LED.

I hold the power switch witch and I get one beep (which is a different tone and duration than the standard turn-on beep), but Iíve held the button for even a full minute and never hear the 3 beeps to signify it is in calibration more for the throttle trigger. As soon as I let off the button the LED goes green and I have no power to the motor. The steering servo works fine and the radio works on my other cars.

Any ideas? Can the programming module be used to rectify? Maybe a firmware update or could it be a hardware problem with the ESC? Just curious if anyone else has experienced this or maybe I missed something before I contact RCJuice.

I thought i saw a thread for the G Force version last week, but I canít seem to find it now.
WhiteLX is offline  
Reply With Quote