Anyone else using the p09x (progressive action on springs)? I have a question...the instructions on Petit RC State the Following:
"Adjusting of the PSS screws (PSS Ride Height).
1. Important! We recommend to try PSS settings on the front suspension of the car first.
2. The using of the PSS settings on the rear suspension was still justified only for the narrow range of track conditions.
3. Put car Race Ready on a Flat Board. Turnout RHS screw until it doesn’t have any contact to the spring anymore.
4. Turn in PSS Screw equally on left and right site to setup a Ride Height from 4.0mm – 5.0mm.
This height is the PSS Ride Height which is responsible for the point of progression start at suspension up travel. As starting point we recommend an PSS Ride height from 4.0mm."
My questions are:
Where is the hook distance (Assuming Layout 1) when first setting up PSS Ride Height of 4.0mm (recommended starting point)? - It has to be at least 1.5mm to get the screwdriver in there for initial set.