R/C Tech Forums - View Single Post - Tekin Rx8 Gen3 Thread
Thread: Tekin Rx8 Gen3 Thread
View Single Post
Old 02-11-2019, 08:52 AM
  #242  
Krio
Tech Champion
iTrader: (159)
 
Krio's Avatar
 
Join Date: Mar 2008
Location: At dirt tracks in Michigan!
Posts: 5,718
Trader Rating: 159 (99%+)
Default
Originally Posted by Fate0n3
Ok question how common is it for a pin to break in the sensor board in the motor? I have a new motor I had mocked up in a Tekno ET48.3 build upon finishing stuff up I went to unhook the sensor wire and a pin from the motor just broke off and pulled off with the sensor wire. I am literally in shock this motor doesn't have 1min of movement on it. How common is this? Is Tekin pretty good about taken care of stuff on support side?
I have literally never heard of that happening locally in 8+ years. Definitely send an email with some pictures and I'm willing to bet they will take care of you 100%.
Krio is offline  
Reply